|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
|
|||||
|
|||||
|
Ok,
on one hand <G11> says you can't use "alignment devices" taht are NOT part of the robot at the beginning of a match or at any other time....,.Fair enough. On the other hand, if some sort of "alignment device" is permanently attached to the robot, then that device likely falls under the classification of a "decoration". Yes? And then, under <R102> and on-board decoration can't affect the outcome of a match and must be in the spirit of "gracious professionalism". Therefore, Perry Mason...case closed. Just line-up within your 5'x5' box of tape and pray you don't go off inthe wrong direction during autonomous mode; hey which end of the robot faces the wall anyways? Oops.... ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| laser pointer | 1574aviad | Technical Discussion | 9 | 02-20-2005 08:25 PM |
| Second Annual Laser Quest Lock-in! | Gui Cavalcanti | Off-Season Events | 3 | 04-29-2004 11:33 PM |
| laser radar with BS2p using RS232 problems... | chei_UCF19 | Programming | 6 | 02-26-2004 03:21 PM |
| Onboard Camera? | XRaVeNX | General Forum | 18 | 02-03-2003 08:28 PM |
| laser guidence for a basic stamp brained valve cover racer | Andrew Wyatt | Technical Discussion | 1 | 06-05-2002 12:14 AM |