|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
|
||||||
|
||||||
|
Re: Kit Transmission
I designed the gearbox with the spacer, because I do not like set set screws. The spacer, combined with the screw and washer at the end of the shaft, positively locates the gearbox in the correct spot. When I did prototyping last year, I used PVC tube for the spacer and it worked fine.
The manual, located at the IFI website, describes all of this in detail and provides a drawing for the spacer. I have attached my original drawing for the spacer in this E-mail. -Paul |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Kit Transmission Upgrade kit | Andy Baker | Extra Discussion | 17 | 29-01-2006 01:27 |
| Tapping Into Kit Transmission Casing | Madison | Technical Discussion | 6 | 13-12-2005 14:29 |
| Kit Transmission Arm Config Update | Paul Copioli | Kit & Additional Hardware | 0 | 21-01-2005 15:07 |
| Kit of Parts - Sprocket Spacers? and Transmission Lubrication? | wmurphy | Kit & Additional Hardware | 10 | 13-01-2005 01:09 |