|
|
|
 The true beauty is, no matter what the game (Yes, even 2001), we spend these 6 weeks going crazy with design strategy, and trying to figure out a way to work the plot twists that the GDC throws at us...and its a blast. - Andy Grady [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
PWMs Active in Programming Mode?
We finally hooked up our new FRC to a pair of VEX servos last night to tinker around with EasyC (we've been messing with LabView and the camera standalone). While walking through the Getting Started section of the help file, we needed to put the FRC into Programming Mode to receive a download. On each occasion, shortly after entering Programming Mode and before actually initiating the download, the servos we had connected to PWM01 and PWM02 went spastic for 2-3 seconds. This was, consistently, about 5-10 seconds *after* the controller was indicating that it was in programming mode.
Has anyone else seen this or should I be calling IFI for a replacement controller? Lynn (D) - Team Voltage 386 Last edited by ldeffenb : 13-01-2006 at 09:15. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RS-232 Programming port as an active interface | Goose | Programming | 1 | 03-04-2005 15:40 |
| Stuck in programming mode | sudeepr71 | Programming | 5 | 20-02-2005 01:01 |
| stuck in programming mode | Shu Song | Control System | 2 | 29-04-2004 16:44 |
| pwms 13 and 15 in autonomous mode | Chris Bright | Programming | 1 | 24-02-2004 22:25 |
| Brake mode on pwm's | snowdragon | General Forum | 4 | 23-02-2004 19:11 |
Threaded Mode