|
|
|
 We have to have a water-based game discussion each year, because every time I try to start up a "jello-based game" thread no one takes me seriously... - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We have to have a water-based game discussion each year, because every time I try to start up a "jello-based game" thread no one takes me seriously... - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
13-01-2006, 09:21
|
||||
|
||||
|
Re: PWMs Active in Programming Mode?
Did this happen before or after you downloaded the code. If it was before the code was downloaded reinstall the master code on the controller an try again. If it is after the code is downloaded then check the code and make sure no one changed any thing.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RS-232 Programming port as an active interface | Goose | Programming | 1 | 03-04-2005 15:40 |
| Stuck in programming mode | sudeepr71 | Programming | 5 | 20-02-2005 01:01 |
| stuck in programming mode | Shu Song | Control System | 2 | 29-04-2004 16:44 |
| pwms 13 and 15 in autonomous mode | Chris Bright | Programming | 1 | 24-02-2004 22:25 |
| Brake mode on pwm's | snowdragon | General Forum | 4 | 23-02-2004 19:11 |
Threaded Mode