|
|
|
 hmmm... big open space between arena and pits... thousands of poof balls...thousands of high school kids hopped up on sugar and robotics.... sounds a little dangerous. - Courtneyb1023 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
connecting CMUCam2 with a PC without the RC
I'm trying to connect the CMUCam2 to the PC in order to use the LabVIEW applications made by Diaz and/or the Java application. I read in the CMUCam2 Workbook that I can connect it to the PC without the need of connecting it to the RC.
how can I do such a thing? I'll be thankful! |
|
#2
13-01-2006, 20:16
|
||||
|
||||
|
Re: connecting CMUCam2 with a PC without the RC
first take a db9 (seriel) cable and run it from the computer to the db9 port on the camera. Then make a power supply (search this site I already posted how) finally plug the servos into servo ports 1 and 2 and you will have a working camera. THen just run the progtram of your choice (CmuCam2 GUI or labview) and you should have a working camera
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Example LabVIEW Apps - Dashboard, CMUcam2 and Motors | Russ Beavis | National Instruments LabVIEW and Data Acquisition | 9 | 21-01-2007 17:19 |
| CMUcam2 disclaimer | Cody Carey | General Forum | 4 | 12-01-2006 01:19 |
| calibrating a cmucam2 | muy dificil | Programming | 2 | 19-09-2005 12:46 |
| CMUcam2 interfacing | Kram | Programming | 2 | 27-05-2005 07:17 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
Linear Mode
