|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
|
||||
|
||||
|
Re: CIM motor shaft Coupler
You could use the old 1" Al hex block, drill appropriate size holes on either side, broach for key stock.
That is what we did on one robot recently Ceal Craig |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Big CIM Motor Specifics | jakey | Motors | 1 | 13-01-2006 01:00 |
| CIM Motors | UlTiMaTeP | Motors | 13 | 10-01-2006 14:48 |
| 6 CIM Motors? | psquared89 | Kit & Additional Hardware | 16 | 09-01-2006 08:47 |
| CIM speed in reverse? | colt527 | Motors | 41 | 06-12-2004 19:09 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |