|
|
|
 All the gangstas in FRC have solid gold CRios. It's called "blingage". If you don't have a solid gold CRio, you're not a straight-up G. :D - Jamie Kalb [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| All the gangstas in FRC have solid gold CRios. It's called "blingage". If you don't have a solid gold CRio, you're not a straight-up G. :D - Jamie Kalb [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
14-01-2006, 17:01
|
||||
|
||||
|
Re: Inventor Help
actually i am having this same problem. i have inventor 5 and 5.3 at home, inventor 8 parts, and inventor 10 on a tiny laptop that doesn't even meet minimum system requirements. unfortunately all of the official parts are in inventor 10 so i can only use the parts on the laptop
i have been trying to rebuild the parts in inventor 5 and solid works but the parts on the innovation site does not have dimensions. apparently they imported or something because it is only a base in inventor 10. does anyone know where i can get parts that are editable so that i can change them to the older versions? i would appreciate it if anyone could give some info. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode