|
|
|
 So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So the bar is set insanely high. Probably unachievably high for some of us. But what a shame it would be to lower it. - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
14-01-2006, 18:22
|
|||||
|
|||||
|
Re: Creating new MPLab Project
With your project open in MPLAB:
Project > Build Options > Project There, select the MPLAB C18 tab and, under Macro Definitions, add _FRC_BOARD. You can also enable code optimizations by editing the "-Ou- -Ot- -Ob- -Op- -Or- -Od- -Opa-" strings. These two posts discuss it in more detail. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming Vex w/ MPLab | dababyjebus | FIRST Tech Challenge | 27 | 25-04-2008 09:11 |
| openFIRST Project Announces Pending Deadline for End of Support for Old Versions | Timothy D. Ginn | FIRST-related Organizations | 0 | 11-07-2005 22:40 |
| Printing of a project in MPLAB | DanDon | Programming | 0 | 10-01-2005 21:10 |
Threaded Mode