|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
|
||||
|
||||
|
Re: CIM motor shaft Coupler
You could drill a 5/16 hole in the end of a 5/8 peice of bar stock(hard with only a drill press, but i think it can be done
). And then you could drill and tap for a set screw on the face of the shaft to hold the output shaft from the CIM motor.Hope this helps. Good Luck |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Big CIM Motor Specifics | jakey | Motors | 1 | 13-01-2006 01:00 |
| CIM Motors | UlTiMaTeP | Motors | 13 | 10-01-2006 14:48 |
| 6 CIM Motors? | psquared89 | Kit & Additional Hardware | 16 | 09-01-2006 08:47 |
| CIM speed in reverse? | colt527 | Motors | 41 | 06-12-2004 19:09 |
| CIM vs. Drill motor | duckshepherd | Motors | 3 | 15-02-2003 18:36 |