|
|
|
 "If everything is possible, there is the possibility that something is impossible..."
::sigh:: :) - Kims Robot [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "If everything is possible, there is the possibility that something is impossible..."
::sigh:: :) - Kims Robot [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Wiring Rules
Section 5.3.9 Wiring Rules states the minimum wire size that must be used for the various circuits. These seem way too small, but I'm used to working with A.C. power not D.C. Is 12AWG wire correct for using on a CIM motor with a 40 amp circuit breaker? If so, would it be best to go with 10AWG wire instead?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| On Rules, Referees, and Rewards (aka Penalties) | RyanMcE | General Forum | 29 | 21-03-2005 13:20 |
| You write the forum rules | Ken Leung | CD Forum Support | 8 | 17-01-2005 11:18 |
| Dilemma - Letter of the rules v. spirit of the rules | Natchez | General Forum | 27 | 03-04-2003 15:37 |
| Time for new rules! | archiver | 2001 | 11 | 24-06-2002 02:01 |
Threaded Mode