|
|
|
 This is high school robotics for fun and education. Let's try and keep it that way. - Rod [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This is high school robotics for fun and education. Let's try and keep it that way. - Rod [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
15-01-2006, 12:19
|
|||
|
|||
|
Re: bending parts
i am concerned that the bends are at right angles and at the right locations so that the holes align when it comes time to close the piece with the gusset. do you think it would help if i screwed a piece of angle stock onto either side of the piece i want to bend so that their ends aligned at the position at which the bend is to occur and use these for leverage and to reinforce the piece on either side of the bend?
figure once i got one i could use it as a template to drill a piece of square tube and use that as suggested. am i over-thinking this? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| **IMPORTANT FIRST EMAIL**/Replacement Parts Deadline Reminder | AmyPrib | FIRST E-Mail Blast Archive | 0 | 11-01-2006 11:48 |
| **FIRST EMAIL**/Replacement Parts Request Process | Pat Fairbank | FIRST E-Mail Blast Archive | 0 | 04-01-2006 17:26 |
| PLEASE RESPOND: NRLB & Spare Parts at Nats | ngreen | Championship Event | 12 | 23-04-2004 16:06 |
| Rules on making spare parts fyi | DougHogg | General Forum | 0 | 02-04-2003 16:18 |
Threaded Mode