Problems tracking with CMUCam2 in LabVIEW

In the end, we were successful, but the tale is one of such stupidity that it should be engraved in drool upon a failed math test. - AmLameBro [more]

		Chief Delphi > Technical > National Instruments LabVIEW and Data Acquisition > LabView and Data Acquisition
Problems tracking with CMUCam2 in LabVIEW

Thread Tools

Rate Thread

Display Modes

16-01-2006, 10:57

PhilBot

Get a life? This IS my life!

AKA: Phil Malone

FRC #1629 (GaCo: The Garrett Coalition)

Team Role: Mentor

Join Date: Jan 2006

Rookie Year: 2006

Location: Maryland

Posts: 747

Re: Example LabVIEW Apps - Dashboard, CMUcam2 and Motors

Thanks Joe.

I see the problem... The assembly diagrams all show the board with the switch at the bottom, but the connection diagram shows it up the other way.

I hadn't noticed those reversing jumpers. Thanks for the excellent tip.

Phil.

Quote:

Originally Posted by Joe Hershberger

Phil,

The power switch should be at the top. If it's not, then the camera is upside down. Try putting a junper on the vertical one.

Good luck!
-Joe

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 01:29.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.