inventor help-installation mess up

[Simon Strauss]

last night i installed the first three Cd's of inventor 10 onto my computer at home but due to my lack of time neglected to install the modules CD thinking that i could do it some other time. However, when i went to do that today i popped the modules CD in and no auto run began nor were there any options for installing this last piece on the first CD. I'm on construction for my team so although most would consider me very computer literate, I'm completely clueless on how i should go about addressing this problem, is there anyway for me to fix this mistake of mine besides uninstalling and reinstalling the whole thing?

[Ed Sparks]

Originally Posted by nycpunk

I'm completely clueless on how i should go about addressing this problem, is there anyway for me to fix this mistake of mine besides uninstalling and reinstalling the whole thing?

I suggest you bite the bullet and start over ....

[Cory]

Originally Posted by nycpunk

last night i installed the first three Cd's of inventor 10 onto my computer at home but due to my lack of time neglected to install the modules CD thinking that i could do it some other time. However, when i went to do that today i popped the modules CD in and no auto run began nor were there any options for installing this last piece on the first CD. I'm on construction for my team so although most would consider me very computer literate, I'm completely clueless on how i should go about addressing this problem, is there anyway for me to fix this mistake of mine besides uninstalling and reinstalling the whole thing?

If you go to "control panel" and then "add or remove programs" you should be able to select "change" for Inventor, and it'll allow you to choose anything that you didn't install before.