|
|
|
 If you don't like getting tipped don't build a robot that tips. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you don't like getting tipped don't build a robot that tips. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
|
Bad Pwm cables
so we were hooking up the the controls to the kit bot today and found 2 bad pwm cables (new from the kit) I just was wondering if anyone else has encountered a bad set of pwm cables in there set.
I guess you can also heed this as a warning if something is not working from your initial setup check the cables. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PWM Extention Cables: 4 Shall Be the Limit | Joe Johnson | FIRST Tech Challenge | 4 | 12-04-2005 23:33 |
| PWM cables: too fragile? what fixes/precautions? | BillCloyes | Control System | 18 | 14-03-2005 17:34 |
| The PWM Cables | amateurrobotguy | General Forum | 1 | 22-02-2005 17:42 |
| Can we shorten the PWM cables? | RAWdealer59 | Electrical | 3 | 18-02-2003 15:49 |
| Loss of signal in PWM cables. | archiver | 2001 | 6 | 23-06-2002 23:29 |
Threaded Mode