Shaft size of Big "FP" CIM Motor

How you say something is often just as important as what you say. - Rachel Lim [more]

		Chief Delphi > Technical > Motors
Shaft size of Big "FP" CIM Motor

Thread Tools

Rate Thread

Display Modes

18-01-2006, 18:05

Andrew Blair Andrew Blair is offline

SAE Formula is FIRST with Gasoline.

FRC #0306 (CRT)

Team Role: Alumni

Join Date: Feb 2005

Rookie Year: 2004

Location: Corry

Posts: 1,193

Andrew Blair has a reputation beyond repute

Send a message via Yahoo to Andrew Blair

Re: Shaft size of Big "FP" CIM Motor

Yes, that's what it appears to be. 5/16 and flat ground on 1 side. However, though it's not a big difference, because it's in the CIM family, might it be 8mm output shaft?

__________________

Reading makes a full man, conference a ready man, and writing an exact man.

-Sir Francis Bacon

"Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction."
-Albert Einstein

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
IGES Model of Large CIM Motor	Madison	SolidWorks	7	16-01-2006 13:27
Large CIM motor specs	ryan_f	Motors	4	13-01-2006 21:38
using set screw or dowel pin/pin to hold on drill motor coupler thinggy	Travis Covington	Motors	1	04-02-2002 03:02
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
Big Shaft to Little Shaft?	Anton Abaya	Technical Discussion	7	21-01-2002 19:27

All times are GMT -5. The time now is 20:22.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.