|
|
|
 (The wheels) need to be green anodized, and then assembled with yellow anodized spinners. ... and then, on the spinners, you can etch "JVN is a dweeb". That would be cool. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Sensors printed incorrectly?
My fellow programmer/electrician just told me that one of the sensors got silk-screened incorrectly.
All of the sensors say BRW on them, but the Yaw Rate Gyro reads BWR on it. I'm guessing that this one is the incorrect one, but I wanted to be sure first. Sorry if this has been covered before, I couldn't find it on search or by browsing through the forums. |
|
#2
18-01-2006, 19:30
|
|||||
|
|||||
|
Re: Sensors printed incorrectly?
yes the GRYO is printed wrong you hook that one up the same way as the others so dont worry just make sure whoever solders the conections on is good at it so they dont fry the chips
|
|
#3
18-01-2006, 20:05
|
||||
|
||||
|
Re: Sensors printed incorrectly?
Yes, check out the 2006_Sensor_Basic_Operation.pdf file available here. The correct label is shown in red on the image of the board.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sharp IR distance sensors | Gdeaver | Electrical | 13 | 10-02-2007 20:36 |
| jumper cabling from sensors to controller | Gary Dillard | Electrical | 4 | 23-12-2005 07:42 |
| Bumper sensors | jeffmorris | FIRST Tech Challenge | 1 | 02-10-2005 16:20 |
| Getting Fancy with Sensors | FadyS. | Programming | 30 | 10-03-2004 15:02 |
| Why not analog sensors?? | gnormhurst | Programming | 16 | 07-03-2004 16:14 |
Linear Mode
