Beware - transmission output shaft is not 5/8"!

I think they get nutrition from chain greese. - Lucid [more]

		Chief Delphi > Technical > Kit & Additional Hardware
Beware - transmission output shaft is not 5/8"!

Thread Tools

Rate Thread

Display Modes

19-01-2006, 14:24

Ken358

Registered User

#0358

Join Date: Jan 2002

Rookie Year: 1999

Location: Hauppauge ny

Posts: 17

Re: Beware - transmission output shaft is not 5/8"!

Yea its a bit of a hassel. Just ream out the sprokets. I think this is the easiest approch. However, You may have to cut the keyway a bit deeper to get the key to fit after reaming.

Ken

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
diameter of transmission output shaft	sj31419	Electrical	5	17-02-2005 22:09
supplier for 5/8" shaft	david.clark	Kit & Additional Hardware	2	17-01-2004 18:13
Cutting the output shaft	Kevin A	Technical Discussion	2	18-02-2003 01:47
Securing hex shaft to drill output	D. Gregory	Technical Discussion	6	24-01-2003 14:05

All times are GMT -5. The time now is 11:31.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.