|
|
|
 When we find bugs at work, we don't ask "who wrote that section of code?" We ask "Who is the best, most knowledgeable person to work on fixing this bug?" - Jon Stratis [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: HELP! Can't Program Robot Controller - LED stays on.
This happened to me a few times. The only way I managed to fix it was just to redownload the code again, even if you haven't changed anything.
|
|
#2
21-01-2006, 18:50
|
|||
|
|||
|
Re: HELP! Can't Program Robot Controller - LED stays on.
http://www2.usfirst.org/2006comp/oth...ices_Rev_B.pdf
Check out the bottom of page 29 there. It won't hurt the controller in any way, so it might be a good thing to try. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2003 robot controller & interface | LGuY | Control System | 3 | 04-04-2004 16:01 |
| Possible Robot controller problems | mpalermo81 | Technical Discussion | 1 | 24-02-2004 22:43 |
| Robot Controller Flips Out | Eko | Programming | 6 | 22-02-2004 22:53 |
| serious problem found - robot controller resets when jarred! | KenWittlief | Electrical | 23 | 19-03-2003 13:30 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |
Hybrid Mode
