|
|
|
 why would someone do that? Go on the internet and tell lies? - MaGiC_PiKaChU [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| why would someone do that? Go on the internet and tell lies? - MaGiC_PiKaChU [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Dewalts modification suggestion
If you are shifting with Dewalt transmissions and if it seems your servo doesn't have enough torque while shifting you may consider removing the spring clip on the top of White Plastic Shifter Tube. This locks into indentations on the bottom of the Magnesium Housing, more specifically, underneath the numbers that indicate which gear you are in.
as per Dr. Joe's request here is a picture, items in red are the ones previously mentioned.  gl everyone P.S. credit to RogerR for this solution Last edited by Stephen Kowski : 22-01-2006 at 21:37. Reason: grammar |
|
#2
05-07-2007, 13:21
|
||||
|
||||
|
Re: Dewalts modification suggestion
We had this problem in competition with one of our DeWalts, and instead of totally removing the clip, I just bent the clip in with some needle nose pliers so that it provided less resistance.
The clips are nice because the lock the DeWalt into a gear, so your servos don't have to be calibrated as precisely. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| White Paper Discuss: Nothing But Dewalts | Joe P | Extra Discussion | 112 | 22-01-2010 00:24 |
| Dewalts Used Last year | Xufer | Motors | 12 | 19-01-2006 21:57 |
| Joystick Modification Question | wmurphy | Control System | 2 | 31-01-2005 00:29 |
| one suggestion to make this forum better | Ken Leung | CD Forum Support | 34 | 23-01-2005 12:42 |
| Another forum suggestion | Kris Verdeyen | CD Forum Support | 2 | 11-06-2002 19:52 |
Hybrid Mode
