|
|
|
 Don't let what you think you can do get in the way of what you can do. - Daniel_LaFleur [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't let what you think you can do get in the way of what you can do. - Daniel_LaFleur [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: problems using gyro/adc code with camera default code
Try going to Project > Set Language Tool Locations > Microchip C18 Toolsuite > Default Search Paths & Directories > Include Search Path What this is providing is the location for it to search for all the compiler includes (the ones in between <>)
Mine is by default nothing, but your system may be set up differently. I'm guessing here, but I would try setting C:\mcc18\h as the location. Good luck, Mike |
|
#2
22-01-2006, 23:09
|
|||
|
|||
|
Re: problems using gyro/adc code with camera default code
sorry, but I haven't been able to post for a bit. it turns out that my prob was that I had a typo. the mentor that's helping me out noticed that after we were going over the code. it wasn't a mispelled word, I just had a 3 in a variable name when there was supposed to be a 1. however, I did still need that p18f8722.h file, so thanks for that, kevin. next time I have a prob, I'll make sure I don't have any typos before I post.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| interrupt in default code | Gal Longin | Programming | 5 | 04-02-2006 20:10 |
| If you could write the default code... | Kevin Watson | Programming | 18 | 04-08-2005 10:41 |
| Combined Camera and PID/Encoder Code | Terry Sherman | Programming | 1 | 14-03-2005 17:59 |
| Best Way To Insert Autonomous Code Into Default then load help.? :-)? | gemccnp | Programming | 2 | 05-02-2005 18:58 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
Hybrid Mode
