|
|
|
 Were going to nationals!?!
Did anyone think of telling me this?
- Beta Version [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Were going to nationals!?!
Did anyone think of telling me this?
- Beta Version [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
T-Slot extruded aluminum
I have read a lot about t-slot extruded aluminum and their advantages (versatility, range of options, prototype ability) and drawbacks (weight, cost) but i haven't found any figures on just how expensive this stuff is per foot.
I am looking at either 1"x1" 80-20 or 30mm x 30mm bosch or item. I understand fasteners are even more but i just want to know a ball park figure. This is for the upper level of the robot and will be used to build the hopper and flywheel mounts and will extend up from the kitbot chassis. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Extruded Aluminum to telescope. | LGuY | Technical Discussion | 21 | 07-02-2005 12:43 |
| Torsional Stiffness of Extruded Aluminum | Ben Piecuch | Technical Discussion | 3 | 19-01-2005 21:55 |
| where can I get info on extruded aluminum? | SCYTE16 | General Forum | 21 | 13-01-2005 14:23 |
| Mini extruded aluminum | Ravi U | Technical Discussion | 7 | 17-01-2004 02:12 |
Threaded Mode