Questions about an Idea for a drivetrain.

[camtunkpa]

I like the weight saving idea of the #25 chain to the front wheels. The biggest concern I see is the wrap of the chain on the drive motor sprocket. I would not trust the design as shown in your sketch, but if you used two small idler sprockets on the outside of the chain you could kill two birds with one stone. If the idler sprockets are mounted just below the motor and kinda close to each other you should be able to get close to 180 degrees of wrap on the drive motor sprocket. Basically the chain going over the top sprocket needs to look more like an upside down 'U' instead of an upside down 'V'. the other thing about the idler sprockets is they will make a good tensioning device. That's just my $.02 overall a good weight saving design that just needs some massaging.