Servo Offset -> Angle conversion

Mentor: How is that held in place? CAD Lead: Go to the hardware store and buy a bag of constraints and put the constraints on the robot. - Kenyow [more]

		Chief Delphi > Technical > Programming
Servo Offset -> Angle conversion

Thread Tools

Rate Thread

Display Modes

29-01-2006, 17:33

bush

Registered User

AKA: Aaron

FRC #0710 (Pine Crest School)

Team Role: Programmer

Join Date: Jan 2006

Rookie Year: 2005

Location: Fort Lauderdale, Florida

Posts: 42

Servo Offset -> Angle conversion

I have estimated the conversion at
Angle = Offset / 2
Does anybody have a more optimal conversion equation?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Servo behavior question / advanced servo/PIC programming question	DanL	Electrical	12	18-10-2005 18:33
Servo command confusion?!?!?!?!	[527]phil	Programming	9	15-07-2005 20:10
Servo Compact Design Problems!!!	Dominator_Legen	Electrical	22	07-04-2005 18:15
Servo Help	Dominator_Legen	Motors	3	11-03-2005 19:50
FIRST-SME membership	archiver	2001	5	24-06-2002 00:41

All times are GMT -5. The time now is 15:26.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.