|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||||
|
|||||
|
Re: Servo Offset -> Angle conversion
That of course assumes that your CENTER pwm values are at 124 and 144 (not hard to change). But then my next question would be, why would the degree change be different for 2 identical servos?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Servo behavior question / advanced servo/PIC programming question | DanL | Electrical | 12 | 18-10-2005 18:33 |
| Servo command confusion?!?!?!?! | [527]phil | Programming | 9 | 15-07-2005 20:10 |
| Servo Compact Design Problems!!! | Dominator_Legen | Electrical | 22 | 07-04-2005 18:15 |
| Servo Help | Dominator_Legen | Motors | 3 | 11-03-2005 19:50 |
| FIRST-SME membership | archiver | 2001 | 5 | 24-06-2002 00:41 |