|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: Dual CIM Dewalt???
Dr. Joe, I remember team 716 did a prototype for a 2 drill dewalt in 2005. I'm sure you could modify it to accept Chips. PM Andy Brockway, I believe he was the creator.
linky linky Last edited by Greg Perkins : 30-01-2006 at 08:33. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CIM Motor Count | Tobaby817 | Motors | 2 | 27-01-2006 11:58 |
| 6 CIM Motors? | psquared89 | Kit & Additional Hardware | 16 | 09-01-2006 08:47 |
| pic: Dual FP motors through a Dewalt XRP | Andy A. | Robot Showcase | 5 | 18-02-2005 09:07 |
| pic: Dewalt Dual Motor | CD47-Bot | Extra Discussion | 8 | 10-12-2004 20:31 |
| CIM speed in reverse? | colt527 | Motors | 41 | 06-12-2004 19:09 |