|
|
|
 If you have time at a competition, stop and thank some of the people wearing the crew shirts. They are working very hard to make sure the competition goes as smoothly as possible. - Greg Young [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
error 5101 : Timeout
We have tried over and over to get labview to work. We have run all the serial port diagnostics we have seen and indeed we have no trouble getting serial communications to the controller board to upload new code.
However, Labview always gives us an error (5101) about the serial port. We have reinstalled Labview and NI-VISA, checked in MAX that our serial ports are configured properly, etc. We finally found a java based gui for testing the camera and it seems to work fine (finally got a frame from our camera!) but we would really love to figure out the problem. Any ideas? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Timeout!! | Ricky Q. | Rules/Strategy | 19 | 01-04-2004 22:03 |
| Bug: Login Problems - Session timeout value too low? | DanL | CD Forum Support | 4 | 09-01-2004 16:33 |
| Microsoft Timeout | AJ Quick | Regional Competitions | 12 | 09-03-2003 17:38 |
| Timeout Ruling Discussion | ram | Off-Season Events | 4 | 29-11-2001 13:38 |
Threaded Mode