|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
Re: Fried Cam?
Umm, it looks like one of our ICs is fried, completely dead. The power cannot be attached the wrong way, I always put the black where the little B is. And even if it was, that wouldn't cause a really big problem, the camera would just not work. It shouldn't get so hot as to burn someone (like me!). I was only feeding it 5V. I contacted IFI, the short was right underneath the lens part of the camera on an IC, but the other heat up quickly as well. Comments or anything? It's very much appreciated guys!
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Steps to make cam work? | magical hands | Programming | 7 | 31-01-2006 17:43 |
| Team 343 Web Cam | Gene F | General Forum | 6 | 20-02-2005 13:28 |
| Questions about cam | magical hands | Programming | 1 | 04-02-2005 17:13 |
| G-Codes vs. CAM / CNC Forums | indieFan | Technical Discussion | 19 | 16-06-2004 22:51 |
| fried | archiver | 2000 | 4 | 23-06-2002 22:45 |