LabView Dashboard Problems

[Mark McLeod]

Originally Posted by brummer_13

alright now that i know what to do, how do i do it. i cant find anywhere how to change the user byte assignments

In user_routines.c you’ll see this example line close to the end:

User_Mode_byte = backup_voltage*10; /* so that decimal doesn't get truncated. */

You can also set the following variables anywhere before a putdata()

• User_Byte1
• User_Byte2
• User_Byte3
• User_Byte4
• User_Byte5
• User_Byte6

So for example: User_Byte1 = 123;

[brummer_13]

Originally Posted by Mark McLeod

In user_routines.c you’ll see this example line close to the end:

User_Mode_byte = backup_voltage*10; /* so that decimal doesn't get truncated. */

You can also set the following variables anywhere before a putdata()

• User_Byte1
• User_Byte2
• User_Byte3
• User_Byte4
• User_Byte5
• User_Byte6

So for example: User_Byte1 = 123;

where is user_routines.c though, i found the file on my comp but i cant open it with wnything. is that what u ment or is it a part of easyc or something