|
|
|
 Searching is your friend - try it. - Katie Reynolds [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Searching is your friend - try it. - Katie Reynolds [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Db9 port
if the db9 serial port is fried, shouldn't the whole camera stop working?
i am asking this when i tried to calibrate the camera using labview, the serial port did not even come up on the aplication. however i was able to uploadd kevin's camera code to the rc. even though the camera did not move. also i accenditly attached the ttl adapter to the rc wrong(backwards) and one fo the pins was touching one of the relay pins, the adapter got realy hot. i quicly turnedoff the rc and removed it. could that have fried the ttl adapter and that is why when i upload kevin's code to the rc the camera does not move or sends data to the terminal window? Last edited by GOshin : 02-02-2006 at 19:45. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CMUcam2 Serial Port Diagnostics | Kevin Watson | Programming | 13 | 18-02-2006 15:05 |
| TTL port to a serial port on a demo board | ImmortalAres | Programming | 16 | 09-07-2005 23:44 |
| Updated: Serial Port Driver Code | Kevin Watson | Programming | 4 | 05-02-2005 18:39 |
| Camera DB9 / Calibration Port | roboticsguy1988 | Programming | 10 | 26-01-2005 14:15 |
| New Serial Port Driver | Kevin Watson | Programming | 16 | 09-01-2005 01:56 |
Threaded Mode