|
|
|
 Real engineers don't need sleep... Just ask our bosses! - Mike Betts [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Real engineers don't need sleep... Just ask our bosses! - Mike Betts [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
PWM Cables
Several questions about the beloved (hated?) PWM cables.
1.) Is there a cheaper place to get them than IFIRobotics? $5 a pop is VERY steep. 2.) Where might I be able to get the connectors to make our own? 3.) Are there any rules about soldering directly to the RC? (Assuming that it was heat-shrink-wrapped (sp/grammar?) so as not to make contact with other parts... 4.) The Servos come in the Generic and Kubosomethingoranother connectors. Maybe if we could find said connectors...? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bad Pwm cables | Greg Needel | Electrical | 7 | 18-01-2006 23:13 |
| PWM Extention Cables: 4 Shall Be the Limit | Joe Johnson | FIRST Tech Challenge | 4 | 12-04-2005 23:33 |
| PWM cables: too fragile? what fixes/precautions? | BillCloyes | Control System | 18 | 14-03-2005 17:34 |
| The PWM Cables | amateurrobotguy | General Forum | 1 | 22-02-2005 17:42 |
| Loss of signal in PWM cables. | archiver | 2001 | 6 | 23-06-2002 23:29 |
Threaded Mode