|
|
|
 Ah, this sounds like a sitcom whose pilot I should write and send to NBC - "Life With Lavery". There's a lot of eating, several practical jokes, and lots of bad hair. - Amanda Morrison [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Gear tooth sensor / GTS on DIO 3,4,5,6?
I'm assuming your issue is accessing which of the interrupts 3-6 went off. If not, sorry -_-
Take a look at Kevin Watson's interrupt tutorial. It gives well annotated code for initializing and using all the interrupts. There is a way to use all 6 pins seperately, all though you need to use the method he does. However, you need to convert it to use the files for the new RC. Replace the #include <ifi_picdefs.h> with #include <p18cxxx>, replace the linker file with the 18c8722.lkr from this year's default code, and change MPLAB's project options to build using the P18C8722 as the processor. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will the gear tooth break? | sanddrag | Technical Discussion | 11 | 23-01-2006 14:24 |
| Gear Tooth Sensor | AMIRAM | Electrical | 2 | 22-01-2006 04:09 |
| Gear tooth sensor vs. Optical Encoders | Avarik | Programming | 7 | 17-01-2006 10:18 |
| Accelerometer vs Gear Tooth Sensors | zdeswarte | Electrical | 4 | 22-01-2005 15:35 |
| gears | Michael Leicht | Inventor | 12 | 16-09-2004 10:52 |
Hybrid Mode
