|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Motors and the High Port Numbers
I have seen a similar issue with the servos on the camera. I had them connected to PWM 1 and 2, and when I accidentally discharged static to the chassis of the robot, or connected the serial cable to the program port, the servos would twitch, big time. This doesn't prove to be an issue with the tracking code, though. I have never connected anything to 13-16, though. I use 16 to power the camera. That's probably all it's good for...
I remember reading somewhere that the new master code cures a twitch, but I don't know if it's the 13-16 issue, and I haven't upgraded, so I don't know. Good luck, JBotAlan |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Automatic Transmission" | Madison | Technical Discussion | 70 | 24-11-2003 09:03 |
| The use of motors and parts in Dean's wheelchair | archiver | 1999 | 4 | 23-06-2002 23:12 |
| Looking for practice motors & extra tape drive parts? | archiver | 2000 | 1 | 23-06-2002 22:54 |
| The scoop on the Jideco motors... | Joe Johnson | Motors | 3 | 30-01-2002 10:00 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |