|
|
|
 unless your team is incredibly beastly, completely ignore the words "cool factor". Coolness does not outweigh functionality. - Sam N. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| unless your team is incredibly beastly, completely ignore the words "cool factor". Coolness does not outweigh functionality. - Sam N. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
error window during tracking...
- The CMUcam2 is connected through the serial port on the computer.
- Using a PWM wire to give power through the controller. - In LabView for serial port, I selected COM1. - Than I clicked the "Run" button. - Everything is running fine. - I click on Grab frame - than I click on the color I want to track. - Than the "Start Grabbing Binary Pixel Maps"... - The camera begins to track! - After about 5 seconds I get the following error... "The application is closing becuase of a reported error. You should confirm that the correct serial port..." (the same message you get when the camera is actually not connected to the serial port. - YET even after the message appears the camera continues to track! This happens everytime! please help! Last edited by Calvin : 05-02-2006 at 16:40. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving robot while tracking with camera questions... | Steve Orr | Programming | 6 | 02-02-2006 22:24 |
| Need a realistic Statics Problem | sanddrag | Technical Discussion | 10 | 05-12-2005 15:07 |
| Camera Tracking Problem | cprogrammer | Programming | 1 | 18-02-2005 15:00 |
| Programming Problem: Extremely Frustrating | chantilly_team | Programming | 19 | 12-02-2005 23:00 |
| Major problem with chipphua motors | aka Scott White | Motors | 18 | 19-03-2002 19:44 |
Threaded Mode