|
|
|
 Often heard exchange in the shop: "The physics don't allow that." "But it's so cool!"
- MBF [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Often heard exchange in the shop: "The physics don't allow that." "But it's so cool!"
- MBF [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Emergency: PID with Wheels Off the Ground
Our programmer is convinced that his encoder-enabled PD code isn't working right because the robot is on the cart with the wheels off the ground, and that it would work if it was tried on the floor. Is this your experience?
The biggest problem is speed oscillations in the wheels (speed goes up and down). Thanks! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PID cmd_drive can't drive straight? | gnormhurst | Programming | 4 | 18-02-2005 01:54 |
| Lots of Wheels and F = u x N | archiver | 2001 | 17 | 23-06-2002 23:37 |
| Good or bad: back wheels coming off the ground | Gui Cavalcanti | Technical Discussion | 2 | 17-03-2002 22:09 |
| Our wheels don't touch the ground! | ahecht | General Forum | 12 | 29-01-2002 19:35 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
Threaded Mode