|
|
|
 I'm totally hooked on reffing now and will be volunteering in the future because of [Beach Blitz]. - Ali Ahmed [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm totally hooked on reffing now and will be volunteering in the future because of [Beach Blitz]. - Ali Ahmed [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Mounting encoders?
I have been having a little problem mounting the encoders for the robot. Plus I am not sure if the encoder is receiving enough electricity. One of the PDF docs says that the encoder needs 12V. Is this true and is there a way around it. I would appreciate any suggestion. Thanks
Waialua Robotics  |
|
#2
10-02-2006, 21:58
|
|||
|
|||
|
Re: Mounting encoders?
What encoder? Did it come in the kit (if so, which sensor is it?), or what part number is it?
|
|
#3
10-02-2006, 22:21
|
|||||
|
|||||
|
Re: Mounting encoders?
See my reply in the Technical Discussion forum. Hope that helps.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mounting encoders? | waialua359 | Technical Discussion | 4 | 13-02-2006 01:57 |
| Vex navigation with ultrasonic and encoders | GlennGraham | Electrical | 4 | 13-01-2006 12:58 |
| Mechanical Wheel Encoders? | Jaine Perotti | Electrical | 15 | 04-12-2004 22:46 |
| new bosch pinion and mounting | ajlapp | Motors | 1 | 08-01-2003 17:16 |
Linear Mode
