|
|
|
 The on-going debate on this thread is just because we care. - Steve Wherry [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| The on-going debate on this thread is just because we care. - Steve Wherry [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pic: 1093 drawer-board closup
|
|
#2
12-02-2006, 00:39
|
||||
|
||||
|
Re: pic: 1093 drawer-board closup
When this drawer is slid into place(I'm assuming this because it's a drawer) is there any manual connecting of wires or is it automatically connect them? Relatedly, when taking it out is there manual disconnect of the wires? It looks most excellent! We have not even started to assemble the electronics into our robot yet.
Relatedly is a word. Edit: I hadn't see the other photo yet. Last edited by 5yearbarna : 12-02-2006 at 00:41. |
|
#3
12-02-2006, 00:51
|
||||
|
||||
|
Re: pic: 1093 drawer-board closup
Very nice. That is an excelent design. Were about is this going to go on your bot? Im assuming underneath somewere. Depending on what kind of game your going to play, that could get in the way a little unless if you build around it which im sure you have.
|
|
#4
12-02-2006, 01:40
|
||||
|
||||
|
Re: pic: 1093 drawer-board closup
Dang it, I thought I was being original by stacking the RC on top of the breaker panel. Nice job though; it looks a bit cleaner than mine, probably because i have almost twice as many victors (lucky.)
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 294 Control Board: View 2 | CD47-Bot | Extra Discussion | 17 | 11-08-2004 17:21 |
| pic: Jesuit 1097 Electronics Board | CD47-Bot | Robot Showcase | 8 | 01-03-2004 12:35 |
Linear Mode
