|
|
|
 FIRST, for me, is about mental wrestling with oneself through the ideas of others and learning through this dialogue. - sammyjalex [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST, for me, is about mental wrestling with oneself through the ideas of others and learning through this dialogue. - sammyjalex [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Large CIM Creating Radio interference
On our prototype we had 2 of the large CIM motors and had the radio reciever on a temporary electrical board. But the Large CIM's and the magnetic fields they produced seemed to cause interfearence with the radio reciever. I wanted to know if any other teams were axpierenceing this problem and what they are doing to solve the issue. I guess lead plating is out of the question.
 |
|
#2
13-02-2006, 14:21
|
||||
|
||||
|
Re: Large CIM Creating Radio interference
If you have excess wire from the controller and radio in a loop, try twisting the loop into a figure-8. Keep stuff away from the motors if you can.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Large CIM Motor Bias | Ceal Craig | Motors | 3 | 09-02-2006 10:20 |
| Sprocket on large CIM | s_forbes | Motors | 9 | 29-01-2006 23:01 |
| Large Cim Motor? | Fishdude404 | Motors | 1 | 27-01-2006 22:36 |
| Breaker for Large CIM | Gamer930 | Electrical | 4 | 27-01-2006 07:52 |
| IGES Model of Large CIM Motor | Madison | SolidWorks | 7 | 16-01-2006 13:27 |
Linear Mode
