|
Re: Persistent "no robot controller found" error
Quote:
|
Originally Posted by teh_r4v3
Make sure that you have the modems on the right sides. I believe the one with the small black antenna should be connected to the RC, and the one with the silver antenna connected to the OI. We did that and spent quite some time troubleshooting before we realized what was going on.  |
I don't see what this has to do with programming it?
What are the LEDs on the RC doing? I had a problem like this, it seemed to be trapped in program mode and wouldn't respond, booting just the master processor. Hold PROG and RESET for about 15 seconds, then release RESET. You should get a green power light, an orange program state light, and three dark LEDs. I may have reversed the procedure to release the buttons, if it doesn't work, try releasing PROGRAM instead of RESET...
__________________
Matt Krass
If I suggest something to try and fix a problem, and you don't understand what I mean, please PM me!
I'm a FIRST relic of sorts, I remember when we used PBASIC and we got CH Flightsticks in the KoP. In my day we didn't have motorized carts, we pushed our robots uphill, both ways! (Houston 2003!)
|
Last year we saved a ton of money by using a good bit of square tubing for the frame of our robot, square tubing is a lot cheaper then C channel. We get to use so much raw material that the cost should go down in certain places. - Derrick Maust [more] 
14-02-2006, 22:52
Similar Threads
Threaded Mode