|
|
|
 sometimes you have to put up with the rain to see the rainbow - Beth Sweet [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| sometimes you have to put up with the rain to see the rainbow - Beth Sweet [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
16-02-2006, 23:55
|
||||
|
||||
|
Re: Gear Tooth Sensor FIRE
Did you hook it up according to this datasheet:
http://www2.usfirst.org/2006comp/oth..._Operation.pdf If you did, it's possible that you just have a faulty gear tooth sensor. EDIT: Make sure that you didnt accidentally get some solder between the wires on the other side of the board, that's happened to me. Also, if you are bolting it to your frame, make sure you put electrical tape on the side that's being bolted so you don't short out the leads on the frame. Last edited by Chriszuma : 17-02-2006 at 00:45. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Tooth Sensor | nukem | Programming | 9 | 04-02-2006 20:21 |
| Will the gear tooth break? | sanddrag | Technical Discussion | 11 | 23-01-2006 14:24 |
| Gear tooth sensor vs. Optical Encoders | Avarik | Programming | 7 | 17-01-2006 10:18 |
| Accelerometer vs Gear Tooth Sensors | zdeswarte | Electrical | 4 | 22-01-2005 15:35 |
| gears | Michael Leicht | Inventor | 12 | 16-09-2004 10:52 |
Threaded Mode