|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||
|
|||
|
Re: HELP! We need pneumatic wiring help!
Yes the above post is correct, however this valve alone isn't enough to stop a cylinder stroke midway. You should use another double solenoid valve so that one valve controls the air into the cylinder and the other valve controls the exhaust. You see you need to lock the air in the exhaust side to stop the cylinder mid stroke. Check out this post:
http://www.chiefdelphi.com/forums/sh...ght=pneumatics Post #11 has a simple diagram that shows you how to do it. Good luck! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring the robot in inventor. | vVigglEs | Inventor | 15 | 06-03-2006 11:35 |
| pneumatic rules ? | mcktim | Rules/Strategy | 2 | 29-01-2006 13:59 |
| Pneumatic Gripper ruling | Nitroxextreme | Pneumatics | 7 | 30-01-2005 13:04 |
| pneumatic wiring | nick_champ_2 | Electrical | 3 | 23-02-2003 01:21 |
| pneumatic wiring | nick_champ_2 | Electrical | 0 | 17-02-2003 18:28 |