Wiring for the allegro gear sensor

Canada has five regional events now. Canada. - Nick Lawrence [more]

		Chief Delphi > Technical > Electrical
Wiring for the allegro gear sensor

Thread Tools

Rate Thread

Display Modes

19-02-2006, 14:54

mechanicalbrain mechanicalbrain is offline

The red haired Dremel gnome!

FRC #0623 (Ohm robotics)

Team Role: Electrical

Join Date: Apr 2005

Rookie Year: 2004

Location: Virginia

Posts: 1,221

mechanicalbrain has a reputation beyond repute

Send a message via AIM to mechanicalbrain

Send a message via Yahoo to mechanicalbrain

Wiring for the allegro gear sensor

Recently we hooked up our gear tooth sensor and found it wasn't working. After looking at all the documentation we realised that they draw on 12 volt.

After looking at the board itself it shows a small 12 over the W terminal. Before I connect anything I wan't to confirm what pin should get 12 volts and whether both sets of pin hookups run on 12 volt or if only one.

__________________
"Oh my God! There's an axe in my head."
623's 2006 home page
random mechanicalbrain slogans

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gear Tooth Sensor FIRE	Aaron_H	Electrical	5	17-02-2006 12:29
Gear Sensor	Ryan O	Programming	3	14-02-2006 09:56
Gear Tooth Sensor	nukem	Programming	9	04-02-2006 20:21
Gear Tooth Sensor	AMIRAM	Electrical	2	22-01-2006 04:09
Gear tooth sensor vs. Optical Encoders	Avarik	Programming	7	17-01-2006 10:18

All times are GMT -5. The time now is 10:12.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.