|
|
|
 I'm somewhat fond of saying, if your robot dosen't weigh 119.99 pounds, you forgot something. - Francis-134 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm somewhat fond of saying, if your robot dosen't weigh 119.99 pounds, you forgot something. - Francis-134 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
21-02-2006, 12:28
|
||||
|
||||
|
Re: CMUCam2 not tracking
I am ahving the same problem. THe camera was tracking w/ the new board and such, but once we wired it and the gear tooth sensor w/ interrupt for th ggear sensor it did what you just said- gives a red light of lock when the robot turns on- all hat it does before this is center. Any help would be greatly apreciated, since alot depends on this camera.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CMUcam2 Serial Port Diagnostics | Kevin Watson | Programming | 13 | 18-02-2006 15:05 |
| Moving robot while tracking with camera questions... | Steve Orr | Programming | 6 | 02-02-2006 22:24 |
| Problems tracking with CMUCam2 in LabVIEW | PhilBot | LabView and Data Acquisition | 5 | 17-01-2006 20:42 |
| CMUcam2 disclaimer | Cody Carey | General Forum | 4 | 12-01-2006 01:19 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
Threaded Mode