|
|
|
 However I do wish to reassure people that the judges did not just fall off the back of a turnip truck... - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| However I do wish to reassure people that the judges did not just fall off the back of a turnip truck... - dtengineering [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#31
28-02-2006, 17:02
|
||||
|
||||
|
Re: GearTooth Sensor Destroying Hopes of Autonomous~!!!!!!
My current setup is using a push switch to simulate the gear tooth sensor. I have it hooked up to rc_dig_in11. I have it printing to screen, and when pushed it shows up as 0, otherwise as 1, so looks like the hardware is working. I'm not sure what to do. The counter is still not counting, it just stays at 0. Thanks again for all the help, it is very much appreciated
 ! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode