|
|
|
 The question is like asking "Is it better to drive by looking at a map the whole time or by remembering where you want to go and watching the road instead?" - lukevanoort [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Advice on burning DVDs
I tried to burn our AVA entry to a DVD but it came out fuzzy & lost half the audio. The original is a Quicktime DV-NTSC file, as required by Autodesk. It's very sharp & the audio is fine.
When I burned our Safety Animation to DVD and it came out perfect. It was also a DV-NTSC file, but in AVI format. The original doesn't look any bettor or worse than our AVA entry. I'm using the Nero 7. Any suggestions/recommendations? I hope I don't have to re-edit the video & save as an AVI file. Last edited by Kevin Thorp : 08-03-2006 at 14:41. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with Team (I Need advice) | Leav | General Forum | 11 | 17-01-2006 06:28 |
| Need Advice on approaching big corps. about money | Ben B | Fundraising | 8 | 05-04-2004 17:49 |
| Dirty Birds need advice | DirtyBird213 | General Forum | 13 | 11-12-2003 21:24 |
| PWM and burning out motors | patrickrd | Technical Discussion | 7 | 19-06-2003 15:30 |
| Regionals start in one week - final advice or tips | Mark Pierce | General Forum | 2 | 02-03-2002 18:49 |
Threaded Mode