|
|
|
 This pic became proof that engineers should never give up thier day jobs! :p - Jay H 237 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This pic became proof that engineers should never give up thier day jobs! :p - Jay H 237 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
08-03-2006, 18:20
|
||||
|
||||
|
Re: Old shop equipment
The oldest tool Ive ever used on a FIRST team was well over 8,000 years old
hard to be certain of the age, it was definately prehistoric. We used it on heat shrink tubing. very primative - very dangerous if you were not carefull! Last edited by KenWittlief : 08-03-2006 at 18:23. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| $5000 for machining equipment. How far will it get us? | sanddrag | Technical Discussion | 18 | 30-03-2006 02:05 |
| LA Regional Machine Shop | sanddrag | Regional Competitions | 4 | 11-02-2005 19:41 |
| Shop Safety Training Resources | Andrew Schuetze | General Forum | 4 | 14-12-2004 13:28 |
| Choosing a machine shop (Re: How important is a machine shop | archiver | 2001 | 9 | 24-06-2002 04:20 |
Threaded Mode