|
|
|
 A lot of the time in FIRST it's not what you have when you enter the program, but what you gain from being in it. - Elgin Clock [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A lot of the time in FIRST it's not what you have when you enter the program, but what you gain from being in it. - Elgin Clock [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
power to the cam?
ok everytime i try to go into labview to config the camera and i hit run, i get this, "The application is closing because of a reported error. You should confirm that the correct serial port has been selected. You should confirm that the camera has power and is connected to the PC via serial cable.", now how the heck do i see if the camera is powered, the pwm out put has power but i dont know if im trying to make a non powered cam to work or not, any help is apreciated
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No power - no problem | P1h3r1e3d13 | General Forum | 2 | 20-02-2006 07:18 |
| Fried Cam? | Denz | Programming | 5 | 01-02-2006 21:43 |
| Steps to make cam work? | magical hands | Programming | 7 | 31-01-2006 17:43 |
| power of globe motor with gear box? | Ken Leung | Motors | 5 | 21-11-2001 13:43 |
| Max mechanical power of motors, how is it useful? | Ken Leung | Motors | 1 | 09-11-2001 14:15 |
Threaded Mode