|
|
|
 254 bends CIM shafts every now and then in the drivetrain. I didn't believe it was possible until I saw it myself. - AustinSchuh [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| 254 bends CIM shafts every now and then in the drivetrain. I didn't believe it was possible until I saw it myself. - AustinSchuh [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
vex programming kit
I just got my self a vex kit and was wondering how necessary the programing kit was or if there was an alternate I could use. So far I only have the basic starter kit but i plan on expanding it when I can.
|
|
#2
30-03-2006, 18:30
|
||||
|
||||
|
Re: vex programming kit
The programming kit will be necessary if you wish to program. While you may not need to use easyC (though I HIGHLY suggest it), you will need the cable that is in the kit. Remember, if you wish to use any of the sensors, you will have to program the RC using the cable from the kit.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming Vex w/ MPLab | dababyjebus | FIRST Tech Challenge | 27 | 25-04-2008 09:11 |
| VEX programming | Gene F | Programming | 14 | 08-08-2006 22:21 |
| VEX Programming Kit Available On-Line | Ken Delaney 357 | FIRST Tech Challenge | 6 | 02-10-2005 11:25 |
| Vex programming kit finally available?? | rswsmay | General Forum | 20 | 27-09-2005 22:08 |
| Programming Vex Starter Kit To Recieve From Serial Port | firetrap | FIRST Tech Challenge | 0 | 26-09-2005 17:27 |
Linear Mode
