Mounting encoder/cutting 12 in axel

[foobert]

i was just wondering if anyone had tried converting one of the encoders to quadrature? either adding another slot type sensor or maybe printing out a disk and sticking it on the disk in the encoder and mounting a couple of reflective sensors. the second method would probably be the easier as far as positioning the sensors since you could make inner and outer patterns 90 degrees out of phase on the disks and then mount the sensors in a line.

just wondering, you know... not really thinking of trying it myself

[gdo]

yes the vex kit comes with two 12" axles. All you need is a hacksaw and a file, nothing more. JUst cut to length and file it down to aviod cuts.

[Gdeaver]

Back in the fall I got the encoders on a square bot. The encoder shape and mounting spacing makes it hard to get them on a square bot.Yes, you'll have to cut the shafts. Hack saw and file or Dremel tool and a cut off wheel. I seem to remember having to change the gear and motor locations. If you use the encoders to drive straight there is one detail in the reading of the counts. You need to program a flip flop. In other words read the left encoder then the right encoder. Adjust speed. Next time through the loop swap the read order of the encoders.

[BanksKid]

yes i have an incredibly important question, how many "clicks" on the vex encoder is 1 complete revolution? we have conflicting data, the easyC says 90, but the sheet in the note book says 100, which is right?