|
|
|
 But don't forget about the little details, that can (and will) come back to haunt you. - Ben Piecuch [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| But don't forget about the little details, that can (and will) come back to haunt you. - Ben Piecuch [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
09-04-2006, 22:47
|
|||
|
|||
|
Re: Mounting encoder/cutting 12 in axel
Back in the fall I got the encoders on a square bot. The encoder shape and mounting spacing makes it hard to get them on a square bot.Yes, you'll have to cut the shafts. Hack saw and file or Dremel tool and a cut off wheel. I seem to remember having to change the gear and motor locations. If you use the encoders to drive straight there is one detail in the reading of the counts. You need to program a flip flop. In other words read the left encoder then the right encoder. Adjust speed. Next time through the loop swap the read order of the encoders.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crazy Frog - Axel F | Elgin Clock | Chit-Chat | 23 | 24-09-2005 22:04 |
| Where are you mounting the camera? | GregG | Programming | 7 | 27-01-2005 00:44 |
| drill motor mounting | whynot | Technical Discussion | 3 | 03-02-2003 08:24 |
| new bosch pinion and mounting | ajlapp | Motors | 1 | 08-01-2003 17:16 |
Threaded Mode