|
|
|
 Go fish, dude. - Bill Gold [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Go fish, dude. - Bill Gold [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
09-04-2006, 23:48
|
||||
|
||||
|
Re: Programming: MotorRcControl() vs GetRxInput()/SetServo()
These commands look interesting. Are they available in EasyC 1.1 or are they from EasyC 2.0? I'm looking for a way to control the two motors in the SquareBot using channel 2 and 3 and then also control the servo using Channel 3 joystick with a side to side motion. The default system works this way, but when I use EasyC to combine autonomy with RC, this ability goes away. Any ideas would be appreciated.
EDIT: Silly me. The commands I was asking about are available in EasyC 1.1, you just have to choose Professional Level via the Options menu. Duh! Last edited by michael714 : 10-04-2006 at 18:59. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming Vex w/ MPLab | dababyjebus | FIRST Tech Challenge | 27 | 25-04-2008 09:11 |
| Programming - Getting Started | Mark McLeod | Programming | 80 | 16-04-2008 23:37 |
| VEX programming | Gene F | Programming | 14 | 08-08-2006 22:21 |
| Programming Forum Warning | Brandon Martus | Announcements | 10 | 29-12-2005 13:32 |
| Robot Programming Education | phrontist | Programming | 11 | 03-05-2004 07:32 |
Threaded Mode